Honeywell Hot Water Heater Gas Control Valve. 4.0 out of 5 stars 173. I have a state industries gs650ybrt 300 water heater with the honeywell electronic gas control valve.
Honeywell Gas Control Valve 7 Flashes Wt8840b1000 Honeywell Water from augustreviews.blogspot.com
If the honeywell water heater status light doesn’t blink but the pilot lights, there may have a defective wiring connection with the gas control valve. Pilot light in a water heater is a small flame that continually operates. There was a recall issue concerning water heater back then in 2019, but it’s a good thing that the product wasn’t honeywell.
Smith, And American Branded Heaters.
1 flash = normal operation. The honeywell water heater has the following temperature settings. The gas valve is a low voltage control (usually 24 vac) that allow gas into the combustion chamber.
When You Turn On Your Hot Water Tap, The Hot Water Flows Out To The Fixture.
It is also an adjustable regulator that insures proper gas pressure for combustion. I am able to get the pilot light to light and after a short delay, the indicator light on the. There was a recall issue concerning water heater back then in 2019, but it’s a good thing that the product wasn’t honeywell.
The Thermostat Is Powered By A Thermocouple.
Faulty gas control valve’s electrical connections. 8 flashes = power off failure. Install control to water tank 1.
It Is Designed To Open Or Close The Gas Flow To The Pilot Or Other Ignition Device And The Main Burner.
Due to a loose connection of the connector, the red status light will not blink. Take the original valve with you to the hardware or gas supply store to get a matching replacement. Honeywell valves offer the user the ability to adjust the temperature of the water, the pilot light and the pressure of the tank in easy to access areas.
Honeywell Water Heater Status Light Blinking 2 Times Means The Thermopile Voltage Is Low.
Read descriptions for imp info volume 1 introduction problem. Smith genuine original equipment manufacturer (oem) part 2 cavity natural thermostat. Now, turn the temperature control knob to the “hot” position for 10 seconds.
Share
Post a Comment
for "Honeywell Hot Water Heater Gas Control Valve"
Post a Comment for "Honeywell Hot Water Heater Gas Control Valve"